Petit tuto qui montre comment modifier ou remettre Ă  0 le compteur d'intervalle de maintenance sur une KIA ĂŠquipe du digital cockpit.How to reset maintenance

Turn IG OFF and then IG ON again to check the warning light type. 2. (1) Check the warning lamp state. Check the vehicle warning lamp state. Check if the warning lamp state is caused by tire low pressure. 3. (2) Check the warning lamp state. Check the vehicle warning lamp state. www.kiatechinfo.com make a free account. It takes some getting used to though because it is a site for their mechanics. You can also go to autozone dot com and make a free account and put in the year, make and model and access the free repair guides. After also looking on my system you could try 504769. This code is related to the car unless the previous owner has change it. A code would be needed for the radio to work and if this isn’t available, we wouldn’t be able to reset this. if this is the case the radio unit will need replacing. I hope this information helps.
Turn Bluetooth off on your smartphone and your Kia. Then restart the vehicle and your electronic device. Once both are restarted, enable Bluetooth on both and try connecting again. Remove all clutter, including coins and pens, from the area near the Kia’s infotainment system to help maximize the Bluetooth signal between the vehicle and your
Yesterday after a decent one hour drive with no problems I parked the Ceed 2010 1.6 diesel manual box. Some hours later, it would not start; the battery would not turn the starter motor. I called a rescue service and they started the car with a power pack. I drove home OK but noticed the following: ESP light on constantly Both trip meters reset KIA Ceed - Steering Rack Failure - edlithgow. So Kia replaced the steering rack in may, however, the EPS light came on again the other day and they have now said the steering column needs replacing at a cost of ÂŁ1800 +. Car is not worth that and unsure what to do. if that was even the issue and needed replacing. Kia CEED/HYUNDAI I30 (2008-2011) Rear Bumper Removal and Installation with Parking Sensor Installation.Kia CEED/HYUNDAI I30 After Market Parking Sensor Insta

11 posts ¡ Joined 2015. #1 ¡ Apr 14, 2016. I have a 2013 Kia Ceed Auto petrol fitted with rear camera and all round parking sensors for the 'self-park' system. Previously the rear sensors went into permanent 'red mode' (continuous sound) and one sensor was replaced. Now the fault has recurred and once again the sensors cause the siren to be

Hi folks, Just to let you know of a problem that occurred not long ago. Noticed the oil level warning light came on so had to check the level. Level was fine, but light stayed illuminated. Here are the steps to locate the OBD II port on a Kia. Open the driver’s door. Look under the dashboard on the driver’s side. Some models require that you remove the rectangular fuse box cover if there is any. Locate the OBD2 port on your Kia. The OBD2 port is a black connector. It has 16 pins, and it is distinguishable by its trapezoidal .
  • gvwnrt87ag.pages.dev/250
  • gvwnrt87ag.pages.dev/348
  • gvwnrt87ag.pages.dev/179
  • gvwnrt87ag.pages.dev/96
  • gvwnrt87ag.pages.dev/117
  • gvwnrt87ag.pages.dev/469
  • gvwnrt87ag.pages.dev/331
  • gvwnrt87ag.pages.dev/5

    • kia ceed 2010 service reset